The BRE / British Stone Stone List


Introduction

Full project details

Stone list

BRE Home Page

British Stone
Home Page

Petrography | Durability | Test Results  

Technical Data Sheet
Grub Purbeck Limestone
Lander's Quarry
Kingston Road, Langton Matravers, Dorset, BH19 3JP
Contact : Lander's Quarries
Tel. 01929 439 205 Fax. 01929 439 268
email: landers@purbeckstone.co.uk 
website : www.purbeckstone.co.uk
Grid reference : SY 9825 7905

Compiled March 2000

 

This data sheet was compiled by the Building Research Establishment (BRE). Where possible, data collected in earlier surveys has been used to help interpret the test results. The data sheet was compiled in March 2000 using the results of tests carried out to the proposed European Standards. The work was carried out by BRE as part of a Partners in Technology Programme funded by the Department of the Environment, Transport and the Regions and Landers Quarry and does not represent an endorsement of the stone by BRE. 

General
The quarry is on the B3069 near Langton Matravers. It was opened in 1920. The quarry has a number of different beds.
The stone is used for walling, door and window surrounds, flooring, paving and many other uses. The depth of the stone varies between beds but most are between 300mm and 380mm. The maximum size quarried is 1800 x 1200 x 400mm and the maximum block size supplied is around 700 x 400 x 140mm. There are good reserves. 

Petrography 
 The stone worked at the quarry is Purbeck Limestone from the Middle Purbeck division of Jurassic age. The stone varies in colour with the Grub being a pale bluish–grey colour with numerous pieces of bluish coloured shell.

Expected Durability and Performance 
It is important that the results from the sodium sulphate crystallisation tests are not viewed in isolation. They should be considered with the results from the porosity and water absorption tests and the performance of the stone in existing buildings. Stone from this area is traditionally used as walling and paving. The crystallisation test results show the stone to be Class A which BRE Report 141 suggest is suitable for all uses and that it should have good resistance to both salt and frost. Based on current research it seems likely that the stone would weather at a rate of between 1 and 2 mm per 100 years but it could be greater in severe exposures or on the edges of stonework. The strength is at the top end of the range for limestones.  

Test Results – Grub Purbeck Limestone (Landers Quarry)
Safety in Use 
Slip Resistance (Note 1) 
Wet: 62 
Values > 40 are considered safe 
Abrasion
Resistance(Note 1)  
21.2 
Values <23.0 are considered suitable for use in heavily trafficked areas 
Strength under load 
1) Compression(Note 2) 
149.7MPa
Loaded perpendicular to the bedding plane ambient humidity 
2) Bending (Note 1) 
8.3MPa
Loaded perpendicular to the bedding plane ambient humidity  
 
N.D.
Not Determined Loaded parallel to the bedding plane ambient humidity  
Porosity and Water Absorption 
1) Porosity (Note 3) 
2.4% 
2) Saturation Coefficient (Note 3) 
0.66 
3) Water Absorption
0.59% (by wt) 
4) Bulk specific gravity 
2635kg/m33 
Resistance to Frost 
Freeze/Thaw Test (Note 1) 

N.D. 

Resistance to Salt 
Sodium Sulphate Crystallisation Test (Note 3) 
-0.08% Mean wt loss 

(Test methods Note 1 = EN1341, Note 2 = EN 1342, Note 3 = EN 1341 /BRE 141, Note 4 = BRE 141)
Tests were carried out at BRE in 1997. N.D. = not determined

Back to top of page | Back to stone list